![]() ![]() 1 digit is allowed even if you use FF9) trailing zeros are not required to fill out the field to the specified width. You can enter fewer digits than you specified (e.g. FF3 supports up to 3 digits after the decimal point and FF9 supports up to 9 digits after the decimal point). The number of digits after the decimal point depends in part upon the exact format specifier (e.g. Snowflake does not support leap seconds or leap-leap seconds values 60 and 61 are rejected. In months that have fewer than 31 days, the actual maximum is the number of days in the month. For example, the year 0000 is accepted, but is incorrect because in the Gregorian calendar the year 1 A.D. Some values outside this range might be accepted in some contexts, but Snowflake recommends using only values in this range. The recommended ranges of values for each field are shown below: Time zone hour and minute, offset from UTC. ![]() Specifying FF is equivalent to FF9 (nanoseconds). Use this only with HH12 ( not with HH24).įractional seconds with precision 0 (seconds) to 9 (nanoseconds), e.g. You can specify AM / PM.Īnte meridiem (am) / post meridiem (pm). when set to 1980, values of 79 and 80 parsed as 20 respectively. Two-digit year, controlled by the TWO_DIGIT_CENTURY_START session parameter, e.g. In input and output formats that you specify in parameters,Ĭonversion functions, you can use the elements listed in the table below.Īlso use these elements to describe the formats recognized by Snowflake automatically. About the Elements Used in Input and Output Formats ¶ ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |